Radio Installation

 

The following is the factory radio installation instructions for late model sprites and midgets (probably 1968-1979) It was Part Number 68P43324A62-0 or 2BM1442. I'll have to find out just what type of condenser was used. However, any polar electrolytic capacitor rated at more than 1000μF and at least 50WVDC maximum should work. In general, the more μF the better. You then connect the negative to ground and the positive to the power lead (unless your car is positive ground in which case its the other way around. This in no way shorts the power lead to ground. Instead it filters out high frequency noise created by the ignition system.

If your radio doesn't have tabs, I recommend fashioning some out of left over steel strap that will bolt on to the ground lead. You can also use strap steel to secure the capacitor to the radio. In the US I can almost guarantee that if you walk into a hardware store and ask for a lockscrew and a spring nut, you'll be met with a curious expression and the question "dont you mean a locknut?". I eventually figured out that a U-nut works great here.