Smiths Fuel Guage

 

This unit is quite simple. Removal merely involves unscrewing a single nut from the back with your fingers and pulling the unit out through the dash. Disconnect the two wires at the back. The terminals don't have any specific polarity so it don't worry about which of the two wires goe sto which of these terminals, it will work equally well either way. Disassembly is as follows.

Remove the bezel, then carefully pull out the face (it's not screwed in and easily comes out). Then unscrew the nuts holding the terminals in place. The rest of the unit will come out the front. thats all there is to it.

The design is quite simple. there is a bimetallic strip with a wire coiled around it. When an electric currant is applied the wire heats up and causes the bimetallic strip to bend. this moves the needle. The sending unit is a variable resistor attached to a float. When the fuel tank is full, the resistance is lowest so the wire in the fuel gage receives the full current of the battery, and when the tank is empty the gage receives no current. In my car there is a 10 volt control box for all dash instruments. I don't know for sure when the factory started using them, but presumably it helps make these gauges more accurate.

Refinishing this gage is interesting since the housing is completely painted light blue inside instead of a blue stripe on a white background. If anything it simplifies the process.