Refinishing Smiths Gages

 

You may have noticed that the lights in your dashboard are rather dim, and that your smiths instruments barely light up enough to see at night. You may also have noticed little white specks appearing on the inside of the glass on a gage or two. Both of these problems may well be the result of old paint flaking off the inside surface. Here's what you'll need to start this project.

  • A spray can of each
    • White semigloss enamel
    • Primer
    • Aircraft Remover
    • a light blue semigloss enamel as close in color to original as possible.
    • Semigloss or flat black
  • High Quality Painters Masking Tape
  • Flathead Screwdriver
  • White Copy Paper

Start by inspecting all the parts including the bezel rings and decide what will need repainting. Next, scratch some marks on the housing so you know where to put the blue stripe. Then take the parts you wish to repaint and strip of all the old paint with the aircraft remover (its does more than remove aircraft you know) making sure to follow the manufacturer's instructions. Next mask off the light bulb holder on the case by stuffing it full of wadded up paper towel bits or wadded up toilet paper. Paint the entire inside surface with a few coats of the primer again following the manufacturers instructions.

It is not necessary to sand the primer because nobody will see the finished result, even a slightly rough inside surface will be more reflective with the new paint job than the old paint was. Then give the inside surface a few coats of the white paint. I got my white paint, my aircraft remover, and my primer from Autozone. Testors Model Master may also work fine.

The blue was a bit trickier. I have yet to find any enamel that exactly duplicates the original color, and for that matter its hard to say just how much that color has faded in the past 40 years or so. What ever you do, do not spray laquer over enamel. The two are not compatible. I tried this once and while the laquer didn't ruin the enamel, it didn't stick to the enamel very well. Just do the best you can at finding a light blue enamel

Now look for the marks you made earlier. Mask the rest of piece off leaving only the space you wish to paint blue. One way to do this is to stuff some paper towels in the back of it, and tape some paper towels down to the sides. Its easiest to start by masking off the beginning and end of the stripe before masking off the side. Follow the manufacturers directions and give it a few coats of blue. When its dry carefully remove the masking.

The front bezel assembly may need refinishing too. The reflector ring is easy enough. Simply strip with the aircraft remover, paint the inside face blue and the outside face black (in that order. No masking is necessary so long as you lay it on a flat sheet of paper and hold the can directly above the work piece. The chrome bezel is a bit more challenging. It is extremely hard to mask off precisely. the best thing to do is strip it, and then paint the entire thing with black enamel. When it dries, take a sheet of white copy paper and gently rub the chrome bezel against it face down. the paper is rough enough to rub off any unwanted paint without disturbing the rest of the paint or scratching the chrome. With enough practice you can get a nice clean line this way. You can also rub the rest of the unwanted paint off around the sides the same way or using a rag if you prefer.