Dynamic Ignition Timing

 

This section is on how to set the dynamic ignition timing. To start with you will need a decent quality timing light with an advance dial. The reason for this is that many spridgets have timing marks only out to 15º BTDC and max advance might be as much as 34º. Maximum timing advance usually happens around 3000 RPM. While the static timing figure listed in the manuals are ideal for a stock distributor, if you have changed your distributor with a performance unit or are unsure of the advance curve, it is really more important to make sure that the maximum advance doesn't cause preignition while also ensuring a reasonably smooth idle. Of course the best course of action is still to take your car to a specialist who can fine tune the advance curve to suit your engine perfectly, but that is expensive. It is worth mentioning that by not taking it to a specialist, you can't be certain that distributor x is right for your car. You get what you pay for to some extent. The important thing is that you don't want preignition, pinging, or detonation as this can cause serious engine damage. Some advance curves may be too radical for you engine.

advance timing light

Still, if you don't have the money to pay for a service that can cost 200 bucks a hour and aren't looking for perfection, the next best thing you can do is buy the aforementioned timing light (similar to the one pictured here). Hook it up to the battery and put the induction coil around the #3 spark plug wire. The timing marks on the 1971 midget I have are visible from under the car (see photo below). You have to look just above the rear of the front crossmember. In some cases a notch is cut into the harmonic balancer or crankshaft pulley. The placement of your timing pointer may vary. Some cars may have parts from other A-Series engined cars. For example, a midget timing cover with a mini cooper front pulley. To be on the safe side, it may be wise to start by ensuring that when the timing mark on the pulley lines up with the TDC timing pointer, that the engine is really at TDC. In some cases it may be helpful to make the mark more visible by coloring the timing mark with a pastel or a dab of brightly colored paint that contrasts with the engine color to help you see it. For more on the timing mark click here.

Just a quick note on the timing pointers. Looking at the engine from the front, the engine will always be turning clockwise. The TDC pointer is the furthest left. The next one to the right is 5º BDTC (before top dead center or 5 degrees ignition advance). The next one to the right of 5º BTDC is 10º BTDC and so on.

Now slacken off the distributor clamp nut, disconnect and plug any vacuum lines to the distributor, start the car and have a friend adjust the distributor while you check the timing. At first just turn the dial until the timing mark aligns with TDC and read what the dial says. If it reads what the manual specifies you may be in the ballpark. Just to be on the safe side, have your friend rev the engine up to 3000-3500 rpm and check to see what the maximum advance is by turning the dial until the timing marks line up with TDC again. The dial should read between 32º and 34º, but some do push it higher. 32º advance is usually on the safe side. In the case of the Aldon 100AYV in my car, neither me nor my helper could hear any pinging during a test drive with it set at 32º advance, and I noticed a marked improvement in throttle response, power.

If you don't know what pinging sounds like, it's best to find someone who does. All I can tell you is that it sounds a bit like marbles in a tin can.

Location of MG Midget Timimg Marks