
Most spridgets use an electric SU fuel pump. Some of the earlier bugeyes may use a mechanical unit that runs off the camshaft, and 1500cc models used mechanical pumps as well. Still, some people find electric pumps more convenient and if you are considering changing to an electric pump, you may find this option interesting SU fuel pumps are essentially a solenoid connected to a rubber diaphragm.
Normally the solenoid is controlled by a set of points. These points can corrode and that can leave you stranded on the side of the road. One way to remedy this problem is to include cleaning or replacing the points in your regular service schedule. Some have also abandoned SU pumps altogether and use a more modern solid state type. Another way to remedy this situation is to replace the original points type fuel pump with a solid state SU fuel pump. Moss USA sells these under part numbers 377-295 for positive ground and part number 377-285 (AUF214EN) for negative ground and refers to these pumps as "Electronic". No conversion kit is currently available so you will have to completely replace the pump here. Here is what you get with this pump.

The box is well packed with bubble wrap and the pump itself is wrapped in two layers of brown wax paper to keep out moisture and inhibit rust. Included is the yellow warranty card below.


As you can see, from the outside, it looks exactly the same as the standard pump. Lets ignore the warranty information and remove the dust cover just to make sure that this is in fact a solid state pump. The dust cap is attached to the cast iron base with a single nut on the top, and sealed with extra wide electrical tape. This is finished off with a blue SU label. As the warranty card says the black tape is used for negative ground units and red tape is used for positive ground units. As the tape ages it becomes brittle and becomes impossible to remove without destroying it. In the field regular electrical tape can be used if need be so long as you make sure that you get a good seal to keep out moisture.


Looks like this really is a solid state unit. At this time I don't have a circuit diagram worked out, but basically it works on a hall effect sensor. As with all other SU pumps, there is a pushrod connecting the diaphram to the points, except in this case a chunk of metal possibly a magnet has been affixed to the top of the pushrod with a tiny alan screw. My guess is that the hall effect sensor measures the movement of this new metal piece, and that all the rest of the circuit deals with switching the solenoid on and off. Since this pump is otherwise identical to the standard design, presumably one could rebuild this pump with standard rebuild parts (while omitting the points of course). Hopefully, this type of pump will give years of trouble free operation. Assuming SU created a durable and robust circuit, the only thing that should require service is the diaphragm.