S.U. Electric Fuel Pump Removal and Reinstallation

 

The Electric SU Fuel Pump is located on the right side of the car under that car just in front of the rear axle. It is held on with two nuts on studs welded to the body. The mount is two straps of steel that wrap around a rubber grommet that slides over the pump. Removal involves using a screwdriver or nut driver to slacken off the hose clamps on the fuel line and disconnecting the fuel lines from the fuel pump. Then remove the nuts on the captive studs. The pump should come out easily. To remove the pump from its mount you will need to remove the two bolts holding the two halves of the mount together. Next slide the rubber grommet off the pump. When reinstalling, always place the outlet at the top as marked on the pump so that fuel can drain back into the fuel tank when the pump is not in use.

If you are changing to a solid state pump, you should note that there is one slight difference on the dust cover. The solid state pump has a metal tube that acts as a vent whereas the stock pump has a plastic cup covering the vent. You can pull the metal tube out with a pair of pliars and switch it over to the factory type. I did so believeing it would help prevent moisture from entering the unit and causing eventual failure.