Seat Belts: Removal and Refitting

 

First off, Your seatbelts could save your life so please don't screw this up. You need to make sure that you NEVER EVER drive without seatbelts. You also need to make sure that all of your bolts are up to the required spec. In addition, doing any work related to seatbelts is at your own risk. You have to take every possible precaution to ensure that they will function when needed. Removal only requires undoing three bolts per belt.

Reinstallation is a bit more interesting. Please don't lose any parts as they are hard to find new or used. As you install the belts make sure they aren't twisted.

There were a number of shims and spacers used in the original installation. I am sorry to say that so far I have yet to find any spridget parts supplier who actually sells these parts. The shims have an outer diameter of 0.85", an internal diameter of about 0.6", and measure 0.015" thick. The shims are made of spring steel and are slightly bent on purpose to keep the seatbelt tabs from rattling around. There are two kinds of spacers. The ones used on the transmission tunnel and for the shoulder belt mount are 0.397" total length. These have an outer diameter of 0.591" for 0.167" of its length and .0756 for 0.230" of its length. The internal diameter is 0.453". The one that is used on the outer sills is the same except longer with a total length of 0.575" and while the two outer diameters are the same as with the other stye but the larger diameter runs along 0.385" of its total length. The bolts used on my car were 7/16 fine thread by 0.866" long (excluding the 0.204" thick head). The hex head was slightly domed and the bolts were chromed. In addition, by the shoulder strap mount, are some vinyl or rubber trim pieces as shown below.

The order that it is supposed to go together is, seatbelt mounting tab, then shim, then spacer, then you tighten it down really tight. I don't have an exact torque figure but they do need to be tight. The end result with the new kangol belts was quite satisfying.