Oil Thermostat Installation: Push On Type

 

When installing an oil cooler it is often best to install an oil thermostat at the same time. That way, the oil will warm up to a normal operating temperature and you will avoid overcooling the oil. Overcooling the oil may result in excessive engine wear. Alternately you can use a shroud to cover your cooler in the winter months but this is less effective since you can't easily get to the oil cooler while you are driving (or when you aren't driving for that matter). The following came with my oil thermostat. I actually ordered a second one from Seven Enterprises when the one from moss didn't come on time. I forget which supplier excluded the following instructions, but hopefully they will be of help to you.

In case you are wondering just how this device works, you will notice that the channel on the lower left doesn't change from Fig 1 to Fig 2. Thats because the rest of the channels flow freely at any temperature. The lower left channel is closed until normal operating temperature is reached. At room temperature the remaining channels are essentially all connected. If you blow through any one of them, you will be able to feel air coming out all the others but one. When it warms up, the last channel opens and oil is allowed to pass through the oil cooler.

As the sheet says, if the engine oil exceeds 140º C it will damage the thermostat. That equals 284º F and is well above normal operating temperature for a Spridget. Also, this unit opens at 176º F which means it may open before the thermostat for your radiator.