Early spridgets used a simple rod to prop open the bonnet and or the boot. Later ones expanded and locked the bonnet and the boot open until a release button is pressed. Hydraulic lifts are used to lift tailgates and hoods on many more modern cars. They make it easy to open and close the bonnet and the boot. In fact once you open it far enough, the lifts take over and open it the rest of the way. In addition, it can help prevent the boot hinges from being bent out of alignment (as happened on my car when a previous owner tried forcing the lid closed while the boot lid telescopic stay was still engaged). Of course there may be a small sacrifice in engine bay accessibility with these installed, but if this conversion is done right, it shouldn't be too hard to remove the lifts if need be. It may be possible to modify the bonnet hinges to use springs to hold it open, but I will have to look into this. I don't know of any commercially marketed kits on the market, but here are some instructions I found on the MG Experience forum written by Doug H of Knoxville Tennessee.
I got the brackets from this site http://www.customgassprings.com/hardware.htm
The hood lifts came from Autozone (due to the fact that the manager let me try different shocks) and are Mighty Lift 4418 (Autozone part number 95774) and rated for 40lbs. I measured from the back fender bolt to the edge of the bracket and that is 21 ½ inches. When I drilled the holes I used a magnet from a transmission oil pan, which was round and had a hole in the center, it caught all the shavings.

On the bracket on the hood, find a of wood that you can slide under the lip so your drill will not put a ding in you hood. I measured the placement of the bottom bracket from the center of the fender bolt to the edge of the bracket, the bracket on the hood measures 5 3/4inch from the back of the lip to the edge of the bracket.

I did the same on the boot. For the Boot, I also got the lift shocks at AutoZone, I don't know the number on the package but the numbers on the shock is 4125 and in smaller numbers 35408. I used ball studs in the holes were the trunk stay was. To get the bracket placement on the right side I used a level laser, leveled it in the hole and shot the line and there was the center mark of the bracket.

Disclaimer: Since I made this up as I went and it works for me. There is a chance it may not work for you. I have had them installed for over a year and have had no problems.
Last updated 8/22/2011