How to Remove The Wiper Motor (later 3 wiper models)

 

This is pretty well explained in the Haynes manual, but pictures do help some folks. Basically i was having some issues with my wipers. It seemed that the motor was struggling to move the wipers at times. So out the motor came so I could clean the cable and inspect the motor. Perhaps more importantly, the rubber in the motor mount had degraded so that the motor was no longer held tightly in place.

Begin by removing the wiper arms. This is done using a posidrive screwdriver (if its the earlier screw on type, some later ones simply snap off). You cannot remove the wiper motor without doing so, since the cable is to be withdrawn from the cable housing and this will cause the wiper shafts to turn at least 360ยบ (probably way more than that).

Next remove the air cleaners (on A-series models, I don't think you need to do this on 1500s).

Next unbolt the metal strap that holds the motor in place. there are only two bolts and its not real hard to get at them.

Here is what the mount looks like out of the car. It consists of a metal strap with a rubber strip on it (for better grip I presume), a rubber pad, and a cast aluminum base. The aluminum base is unavailible new, but the strap and pad can be purchased from either moss USA or Moss Europe. As the pad ages, it loses some of it's elasticity, and stops holding the motor effectively.

Next we slacken off the nut that connects the cable housing to the motor.

A this point there is no longer anything holding the motor in place. Carefully move the motor away from the cable housing and pull the cable out of the housing. Inspect the cable for rust and old grease. Mine had both. I then took the cover off to inspect the grease in the motor. The motor is fairly easy to take apart.

As filthy as it may look in the picture, the grease seemed to be in decent shape and nothing really looked amiss, so I put it back together and bench tested it. When everything worked fine, I gave the cable a thorough cleaning, gave it a liberal coat of grease and then put the motor back in the car. Reinstallation is the reverse of removal. All this was done in May of 2011.