How to Bench Test The Wiper Motor (Permenant Magnet Type Negative Ground)

 

WARNING, The following only works if your car is NEGATIVE GROUND!

Basically to bench test your wiper motor you will want to test it's three modes of operation. High speed, low speed, and self park. The easiest way to do this is to put the motor in a bench vice, connect the vice to the ground of your car with the negative end of your jumper cables, and then clip the red cable to the positive battery terminal in the car on one end, and then just clip the remaining end on the black cable to keep it handy. Next you will need a pair of wires with small alligator clips. Connect one wire to the positive jumper cable and one to negative. It is a good idea to write down or photograph just how the motor's connector is wired.

According to Rick Astley's book, Classic British Car Electrical Systems, and the photo on the left, there should be 5 wires in the connector, a black wire (terminal 1), a Brown/Lt Green wire (terminal 2), a Blue/Lt Green wire (terminal 3), a solid green wire (terminal 4), and a Red/Lt Green Wire (terminal 5). Terminals are numbered as shown.

To test the motor, connect terminal 1 to ground (this is what is shown in the photo at top) You will leave this terminal connected to ground for all tests. Now for testing normal speed, connect terminal 5 to the positive jumper cable. The motor should turn and the cable should move in and out of the motor. To test high speed, connect terminal 3 to the positive jumper cable. It should move the cable much faster than in the previous test. To test auto park you will need a third wire with alligator clips. Connect terminal 4 to the positive jumper cable, and connect terminals 2 and 5 together. Assuming that the motor was not in park position, you should see the motor move and then come to a stop. In all of these tests, you may grab the drive cable and get a sense of just how strongly it pulls. The motor should have a very healthy tug.