Air Restrictor 12G 1797

 

One of the more irritating issues with the air injection system is that in order for the gulp valve to function properly, an air restrictor must be installed on the air pumps connection to the gulp valves intake hose. It shows up in the factory parts list diagram below as part 35

What is so irritating about this piece? Well, its not held in place by anything other than the hose, and when the air pump is removed (which is essential whenever you want to remove the spark plug on cylinder #1 or perform some other servicing operations) this piece is easily lost. Worst of all, this part is no longer manufactured! As a result i have taken some measurements of an example and list them here. You need not have one fabricated from steel or aluminum, although that is your perogative. You could just try to fabricate something with the same bore air passage that you can insert into either the port on the air pump or the hose.

Here is a cross section of the part in question. It is to scale.

The bore is 0.192", overall length is 0.752, outer diameter is 0.482" on the right, and 0.622" on the left. The shoulder is 0.255" thick and all edges are as shown. The part could possibly be replicated by nesting hoses one inside the other until the necessary internal diameter is achieved.