The Following Article comes from Norm Kerr – Originally Published on the MG Experience 2011-01-24. Use by permission
Rear End Noise
- Loud whine/howl at speed = ring and pinion are shot (gear tooth surface worn/damaged). Replace diff with a used one (typically, they last 150k miles with no maintenance, as long as they are never run dry, and never been exposed to broken half shaft fragments).
- Clunk noise:
- Worn U-Joint (there should be no play in either U joint)
- Loose brake back plate (confirm bolts tight and holes not oval)
- Shaft worn at diff (max 0.010" spline wear as shown above). The half shafts seem to be softer than diff gear, so the half shafts wear first.
- Wire wheel spline wear (new splines are squared off on the top, worn splines are pointed). Clean off the grease from both the hub and the rim and then check the play without the nut. Maximum 1/8" play at tire. Replace wheels and hubs at the same time (one new one will quickly wear the other). They are NOT cheap (new hubs and wheels), so don't do it half way. Think of how nice wire wheels look, while you are writing the check. Original hub spline outside diameter 2.450". Note, though, that a fair amount of spline wear can occur before this diameter decreases by much, hence the tire rotation test above, which directly measures the wear as a rotational free play.
- Worn splines encourage extremely tight wheel nut (pounding with a hammer to try and hold the wheel still by friction), which leads to spline bottoming out on the inner taper of the hub. So, spline marks on that taper can be an indirect indicator of worn splines.
Photo of extremely worn splines shown on right, brand new hub on left. Note that the teeth themselves "look OK". The big telltale is the large amount of free play (tire rotation check without the nut as described above) and the spine marks in the inner cone surface from a habitually over-tightened nut from someone trying to quieten down that "click/clunk" noise the worn splines were making.