Differential 101

 

The Following Article comes from Norm Kerr – Originally Published on the MG Experience 2011-01-24. Use by permission

Differential

  • Pinion play should be 0.0 fore-aft, and max 1/4" rotational play (if much more than 1/4", diff is probably toast)
  • 1978-1980 Midgets came with 3.77 ratio (8/'77, from GAN6-200001), better for highway use than the 3.9 used from 12/1968-1977 (but the 3.77s are rare, so more expensive). "58 ~ '68 (948 and 1098cc) used 4.22. The ratio is stamped on the upper RH surface of the diff housing.

Photo of 3.9 diff ratio stamp ("10/39")

  • To replace pinion seal, ideally, you should remove and rebuild the pumpkin properly. But if you are a gambler, you can try to replace it on the car: mark the nut location/flat position of the nut before you start out, and re-install it with the EXACT same amount of rotation. Not doing this will mess up the pre-load and require replacement of the crush spacer, which requires disassembly of the differential unit. If you try doing it on the car this way, make sure you also re-install the pinion input shaft on the same spline (otherwise, your mark you made to reinstall the nut won't be in the right place!)
  • The proper way to replace this seal is to do it on a bench, and use a new crush spacer. Here is a photo of one good way to hold the pinion when torquing on a bench (by using a few feet of angle iron, some straight stock with some holes drilled and some nuts/bolts:
  • The planet and sun gears have thrust washers that wear away over time, and can be replaced, but the ring gear (crown wheel in British speak) must be removed to access the lock pin to service them (unlike an MBG diff which can be accessed directly).
  • Trying to judge pinion free play on the car can be misleading because holding the tire and rotating the pinion will show you several free-plays combined: wire wheel play, half shaft spline wear/play and pinion/crown wheel play. Measuring the play of a diff on the bench is the accurate way, with a dial indicator. The spec is engraved on the back of the gear (each matched set will have a matching set number, and the crown wheel play for that matched set, and the amount of shim offset to the right or left, all engraved on the back of the crown wheel.
  • There are three numbers etched into the edge of the ring gear (crown wheel). The first one is the "match set number" that also is etched into the pinion. The second is the backlash (in this case, it is 0.005"). The third is the packing dimension for shimming the crown's cross car spacing to the pinion centerline.
  • After a half shaft break, or any time the rear end has been apart, it is wise to assure that the insides are surgically clean for maximum diff life: refill the axle with kerosene, with the car up on jack stands, and run the engine in gear for a minute (i.e. no load) and then drain through a strainer. Repeat until the kerosene drains clean (may take several cycles). Fill with 80/90 gear oil (2.1 US pints / 0.99 liters). Run 100 miles and replace that with fresh gear oil.
  • The drain/fill plugs have a tapered square hole that can be fitted with the square end of a 1/2" ratchet wrench, but the taper of the hole can make doing this problematic. Hardware stores sell the same size pipe nipples with a normal, hex drive shaped hole to ease future servicing, or you can buy a ratchet extension and grind it down to match the taper of the original plug, if you want.