Our story begins in May of 2008 when I purchased a Maniflow exhaust system for an MG Midget from APT but was accidentally sent a single muffler exhaust system for a Morris Minor. The Minor's exhaust is routed OVER the rear axle and is longer than the Spridget's which is routed UNDER the rear axle. I made a few videos back then while the parts were still new and I was still excited about it.
However soon after the second video it was time to install it and thats when my enthusiasm waned. I discovered that the only way to install it was to drill another hole and bend the muffler hanger a little and that the tailpipe would hang out the back WAY too far.

Calling APT at the time didn't result in any resolution or satisfaction. They insisted they sent me the right part and I was happy with the increase in performance i felt with my butt dyno. The system they shipped does not match the pictures currently displayed on their website. The coating on the outside lasted untll the winter of 08-09 when I drove it in the snow and I'm guessing the thermal shock caused it to flake off the outside. There does seem to be some coating on the inside of the pipe 4 years later though, but back then I was disappointed and thought the coating process had been in vain.
The other problem with installation was that the LCB was not designed to be installed with the engine in the car. I had to cut away at some gussets near the frame to get it in. After 4 years of smacking the tailpipe every time I left a parking lot or going over speed bumps, one of the exhaust hangers cracked, and there wasn't much holding the muffler on anymore. Nearly every trip in the car resulted in having to get out of the car and put the muffler back on.
It was time to fix this problem the only way I could. I took the car to Midas after 4 years of living with the problem. This maniflow system has 1.5" pipes and the local midas had to order that. Thus instead of taking an hour or two to complete, they got the car in the air only to discover that I would need to return the following day when the pipe arrived. The first step was explaining what the problem was and what I wanted. After which they set to work.
This next picture shows the pipe as installed.
Because of where the joint in the pipe was, it was neccesary to cut the pipe, and then fabricate a short extension. You can see in the next pictures how far the tailpipe stuck out and how the tailpipe angled downward slightly
| After fabricating a short extension and moving the muffler things looked much better | Here's the extension before welding. |
![]() |
![]() |
So far this has been a huge improvement. The corrective surgery cost 120 bucks The moral is, make sure you buy the right exhaust system for your car the first time, test fit it before you ceramic coat it (if it doesn't fit return it or have a pro modify it), and finally don't drive your car in snow and salt with a ceramic coated exhaust.
-Seth Jones 4/28/2012
UPDATE: at the tune up party it was discovered that doing this modification on this type of lift was a mistake and there are clearance issues with the pipe that need to be resolved before I fix the rear springs. - 5/9/2012
UPDATE 2: I took the car back to midas, and they replace the extension with onethat had only one bend immidiately under the rear axle with it on the correct type of rack so the axle could hange free below the car. They gave me too much clearence this time. I wasn't about to go back to have them correct that too, since it was easily fixed using a floor jack (while the car was on jack stands). Now its perfect.



