On Lucas points type distributors it is necessary to periodically adjust the points gap. If the gap isnt properly adjust, the engine may misfire, backfire, or not run at all. At the center of the distributor is the cam. Resting against the cam is a cam follower. The cam follower is made of plastic and does wear over time. The Picture on the left is a brand new Lucas 25D cam follower and on the right is one that was worn so badly that the points couldn't be adjusted to open any more than 0.005". As you can see, it doesnt have to wear very much before it becomes a problem. Fortunately, this kind of wear usually results from years and years of neglect or daily driving. This example had some rust on the cam.


Fortunately replacement and adjustment of the points is quite simple. All you need is a flat blade screwdriver, possibly also a phillips screwdriver, a feeler guage, and if applicable, a new set of points and condensor. On both the 25D and 45D, the adjustment screw also fastens the points to the distributor. On a 25D at the opposite end of the spring from the points is a nut that holds the spade connectors for the condensor and low tension lead for the coil. This nut must also be removed when changing the points. On a 45D the condensor wire is held in place by the spring. It is critical that the connector not be shorted to any other metal part inside the distributor as this will cause a short. This is true of both 25D and 45D distributors. The metal tab slied into a slot on the spring and the spring snaps onto an insulated pedistal as shown below.
The condensor itself is held in place with a single screw. Just unscrew the old points, condensor and the nut (25D) or unclip the connector (45D, then install the new parts, making sure to connect the condensor and the low tension lead to the spring. Leave the adjustment screw a little loose, just tight enough to hold the points in place.
Turn the cam untill the follower rests on the center of one of the lobes. This is where the points should open their farthest. Most lucas points distributors have a feature to aid adjustment. The 25D has a notch in the points that corresponds to a notch in the base plate. The 45D has a notch in the points and a bump in the baseplate. See below circled in blue.
| 25D | 45D |
If you put a flat bladed screwdriver in that notch you will find it quite easy to make very fine adjustments to the points gap. Turn the screwdriver and then check the gap with the feelerguage. The points gap should be between 0.014" and 0.016". You will know wthen the proper gap is achieved when the feeler guage slightly drags through the points, doesnt feel loose, and doesn't move the points.
| 25D | 45D |