The timing mark on the harmonic balencer pulley of an a-series engined spridget can be one of the most elusive prey you will ever have to hunt for. On 948 and 1098cc cars its on the front crankshaft pulley (which is made of stamped metal). 1275's feature a harmonic balencer which has a dimple drilled into the front (probably to balence the balencer) that is frequently confused for the timing mark. To begin with lets look at a picture of the only way to view the timing mark. You have to jack up the front of the car and look through a gap between the front cross members

Unfortunately on all a-series spridgets the timing mark is a notch in the rear flange of the pulley. which means it kinda hides buhind the fan belt. This is at once the best and worst place for the timing mark. It's the best place because it is close to the timing marks and therefore, it is accurate. It is the worst because its not terribly visible. Lets take another look with the engine out of the car (click to enlarge).
One important note. Before the harmonic balencer came along it was apparently easier to see the timing mark. Whats more, the factory manual even shows a picture of the timing mark very clearly. Later editions showed the harmonic balencer pulley and didnt show the timing mark as clearly. Its almost as if the factory were trying to prevent the end user from knowing how to set the timing properly. If they were it wouldn't surprise me. After all they have to build a car that will reliably pass emissions and we can't have just anyone messing with the timing settings now can we!
![]() | ![]() |
|
|
One solution is to paint the pulley or harmonic balencer in such a way that the timing mark is more visible. This can be dine with white out or touch up paint or anything else you have handy. It is best done outside the car with a fine brush.
Another solution is to relocate the timing marks to the top where they are more visible. This is commonly done using a kit provided by Advanced Distributors. See Image below. I suppose that if you were industrious and resourseful you could make this setup on your own, but the kit is only 20 bucks. If in the future the kit is no longer availible I will provide instructions on how to do this from scratch.




