This is one of the achillies heals of the A-Series spridget. The clutch release bearing (or throwout bearing), is made of carbon or graphite bonded to a cast iron shell. This design wears out quicker than the rest of the clutch system. It is very likely that you will end up replacing the throwout bearing long before the clutch plate, clutch cover, or flywheel need any attention. Any time the engine and/or gearbox is removed from the car, this part should be inspected. Back when my car was used as a daily driver by my dad, teh engine had to come out every 3-5 years to replace this part.
Below are some bearings. On the far left is a brand new one. In the middle is one that doesn't have much bearing material left and should be replaced. On the far right is one that has worn down past the edge of the shell. the bearing can wear still further, metal on mental and even break in two. It should be replaced long before that. The more worn this bearing gets, the further the clutch pedal must travel before clutch is disengaged.

It is possible to replace this with a roller bearing type. You can either modify the OEM bearing using a throwout bearing from a 1992-2007 Honda Civic (for instructions click here), or you can buy one from Peter May Engineering.