Ribcase gearbox Speedo pinion

 

If your speedometer doesn't work, one possible cause is a failed speedometer drive pinion. Inside the rear extension of the gearbox is a worm gear that turns the speedometer pinion. This is located just aft of the oil fill plug on the left side of the car. The pinion (10) is made of nylon pressed onto a splined metal shaft and the whole thing fits into a nylon bushing (11) that threads into the gearbox and allowes you to connect your speedometer cable to the gearbox.

This all works well enough except that sometimes the speedometer pinion breaks free of its metal shaft. Should anything in the speedometer drivetrain get jammed or gummed up, this can happen. In this case, the shaft is jammed in the bushing.

This pinion was replaced in 2000 shortly after I got my MG Midget from my dad. It worked ok for a year or two before I hit a pothole on Lake Shore Drive in chicago and the speedometer quit working.

This is the second time this part failed in this way, so I presome it is a common issue. It was probably designed to break free since it is easier and less expensive to replace this piece than it ever would be to replace the worm gear.

 

Next is a picture of what happened to the rest of the pinion gear. It can be tricky to remove the nylon gear once it has separated from the metal shaft. Whatever you do, you don't want to let it fall down into the rear extension where it will rattle around forever. If you have the gearbox out, you can shake it out through the hole where the remote meets the rear extension. Thats what I ended up having to do. I would recommend replacing both the pinion and the bush at the same time. There is an oil seal in the bush that should also be replaced. It might come with the bushing.

NOTE: at the time of writing, for some weird reason this little plastic gear is now selling for about $140 bucks from victoria british and Moss USA. The worm gear is selling for a mere 20-25 bucks.