Ribcase Gearbox Front Seal

 

The front seal in the front cover is of the scroll seal type. There is no rubber oil seal here, much like there is no rubber oil seal on the back of the A-series engine. Unlike the scroll seal on the rear of the engine (which is machined onto the crankshaft), the scroll is machined into the cover of the casting not the input shaft. See picture below.

The original factory part number for teh coverwas 22G 118. To my knowledge the original type is NLA. Moss Motors USA sells a replacement front cover that uses a rubber lip oil seal. It is part number 461-765 and at the time of writing sells for about $175. That is actually a bit pricy. Some companies offer rebuilt ones that use modern lip type oil seals for about half that price. Spridgetmania is one example.

Here is a pictire of what the rubber lip type oil seel looks like installed (click to enlarge).

Basically you just need to get the front cover machined to accept the oil seal. This one shows part number CR8624 on it. That seal is a CRW1 type with an inside diameter of 0.875", an outside diameter of 1.25", and measures 0.188" wide manufactured by SKF group. A good machine shop should be able to install this seal. At the time of writing, the seal by itself costs about $4.65. The seal installation shown in the picture doesnt appear to be the best IMHO. If you can, try to get the seal installed from the inside of the front cover, rather than from the outside. That should improve the ability of the oil to drain back into the gearbox.