There are many occasions where one must remove the hub. Anything from replacing the brake disks and even rebuilding the front suspension can require hub removal. On wire wheel cars this presents a little bit more of a challenge. Unlike on steel wheel cars the grease cap is buried at the end of a deep tube. Fortunately, there is a 5/16" U.N.F. stud welded onto every last one of them. Depending on how old your grease caps are, the stud may be only an inch long (this was the original length back in '65), or it may be so long it nearly sticks out the end of the hub.
![]() | ![]() |
Removing the cap is done by pulling on this stud. Moss makes a special tool for this that can be around 40 bucks. You can grab it with some pliers sometimes, or possibly atatch a slide hammer somehow. I simply went to a hardware store and bought a 1/4" turnbuckle, drilled out the reverse thread side and retapped it for 5/16" fine thread. Note: don't bother getting a stainless steel turnbuckle, that only means stainless steel screw eyes, the rest is still made of aluminum.

There are a number of ways you can go from this pint. You can slide a screwdriver through the turnbuckle and pry against the hub, on OEM units it is possible to slip a large flat blade screwdriver through the turnbuckle and tighten down the screw eye (the extra length of the stud on new units makes this impossible). Reinstalling the grease cap is far simpler. Find a large deep socket to use as a drift (as they say in the U.K.). Then tap it into place with a hammer.

