The E-clip or circlip used to hold the slave cylinder in place is worth discussing. First of all You should know (if you don't already) that the E-clips are Lockheed's later idea and were never on the cars from the factory. Should you choose to use the e-clips, they only fit one way. When looking at the slave cylinder from behind the back plate the clip goes on so that it is convex or bends away from you and the e should face upward like a letter w. Admittedly this is more difficult and perhaps counterintuitive, but it does result in the slave cylinder being held a great deal tighter. To do this, I recommend using a pair of medium sized flat head screwdrivers to stretch the clip over the flange on the wheel cylinder and then working each of the three tabs on the clip into the slot on the slave cylinder. However there is also an actual tool to do this, and you can find instructions on how to make one here.

Originally they had a "Belleville washer" and a plain old cir clip (see illustration above #18 and #19) that probably was a lot easier to deal with. There simply isn't much clearance for the e-clips. The factory part numbers for the factory setup is 17H7613 for the washers, and 17H7622 for the circlips. Little British Car Co still sells the circlips. A belleville washer is dished or conical.
The only supplier at the momment that has something that approximates OEM style, is Granger Products and McMaster-Carr. Granger sells them in packs of 10 only, which should last you a very long time. These were suggested by MG Experience Forum Member Norm Kerr
Grainger #5DA81 = 11/16" external retaining ring, stainless steel.
Grainger #6ZA12 = 11/16" wave washer (3 wave), stainless steel.
Alternately they do have an actual belleville washer that may be closer to OEM
Granger #22RE71 = Disc Spring, Steel, I.D. 0.692 In
McMaster-Carr has the circlips and wave washers for less money and in smaller quantities. The washers are sold in packs of 10, but likewise cost half as much as the granger ones.
McMaster-Carr 91590A127 = 11/16" external retaining ring, stainless steel.
McMaster-Carr 92161A035 = 11/16" wave washer (3 wave), stainless steel.