Quarter Light Window Handle Removal/Reinstallation (1964 and later)

 

This is one of those things that is not immediately obvious and is not mentioned in the factory or hayns repair manual but since the death of BL has become a bit more important. Should your handle(s) be missing, here is how they go on, and what they look like. There were two basic styles of handle BTW but they both go on the same way (both are pictured below in the excerpt from the factory parts catalogue. Right now, I am not sure if you can put an early handle on a later car, without replacing the entire quarter light assembly. The bracket the handle attaches to has a different part number, and the bracket is riveted to the window frame. Even in 1976 you could not buy a bracket separite from the window.

I just took apart two doors to get these out for a buddy who needed them. The handles are held onto a shaft with a pin. What follows is exerpted from from the 1976 factory parts caataloge (AKM0036 Group J published 1976).

Illus # Part # Description # Req
13) 27H 3351 Bracket curved locking handle with pivot NLA
13) 37H 4347 Bracket flat locking handle with pivot NLA
14) AHA 7554 Rivet-bracket to inner frame 2
15) AHA 7473 Washer-waved 2
16) AHA 7469 Handle-curved locking-RH $ NLA
16) AHA 7469 Handle-curved locking-LH $ 1
17) AHA 8446 Handle-flat locking-RH $ 1
17) AHA 8447 Handle-flat locking-LH $ 1
18) AHA 7474 Pin-locking handle $ 2
19) AHA 7475 Plate-catch-locking handle-RH 1
19) AHA 7476 Plate-catch-locking handle-LH 1

Since that illustration only gies a rough idea of how it all goes together and what is involved, here are some photographs. Basically you have to find a punch to push pin (AHA7474) out. This pin rides in a groove on the shaft of the bracket, it doesnt go through. In this way, the factory was able to use the same bracket on each side.. There is no hole in the glass, and teh shaft is a lot shorter than you might think. The bracket wraps around the glass, and the shaft doesnt pierce the glass. The wavy washer keeps it from rattling and probibly helps keep the shaft from touching the glass.