The following tech tip was submitted by Larry Noel from Montana.
There is more than one way to skin a cat. This is just how I painted the strips. Very easy to do. I used a 2 stage base coat, clear coat. I started with a green base coat. I used on 1/2" wide blue plastic pin strip tape down the center of the hood. The main stripes are 5 1/2" wide. Use 1/4" blue plastic pin stripe tape on the outer edge of the stripes. Now place another 1/4" wide strip of tape right next to the first 1/4" strip of tape you just put down. Now place a third strip of tape down right next to the last strip you just put down. Now you have three 1/4" strips of tape in a row. Now remove the middle strip of 1/4" tape. Now you will see a 5 1/2" stripe. Then blue tape and a 1/4" strip and blue tape again. Tape off the outside edges of the 1/4" blue tape with paper. Now paint over the exposed paint and the tape you put down. Now peel the tape and paper off while the paint is still wet. Do not wait until it is dry or it will chip when you remove the tape. Now you can paint over the hole hood with clear coat. Let it dry and polish or color sand then polish as I did to make the baby shine.
