Originally the SU carbs came with a highly polished finish on the dashpots. Thats the bell shapped vacuum chamber that sits on top of the carburettor body. Like the rest of the unit, the dashpot is made of aluminum. Aluminum corrodes very quickly and easily in the presence of oxygen. If you manage to chemically remove the corrosion or even blast it, the metal tarnishes fairly quicly. After 30-40 years of abuse and neglect any aluminum part can look pretty bad. A note of caution before continuing: only sand and polish the outside, dont touch the carefully machined insides.
In the image below we see a before and after. These are both HS2 dashpots I got at the annual All British Swap Meet and Auto Jumble in Wheaton Illinois this year. They were manufactured sometime between 1963 and 1974 and both were in the same shape when I found them.
There are basically three ways to get this result. First there is the chrome dashpot cover that is availible frommost british car parts suppliers. Then there are methods that involve power tools like buffer wheels or lathes or other such equipment, but you dont really need any special equipment, just a selection of sandpapers, #00 steel wool, an old sock, some mothers aluminum polish, and lots of elbow grease. Not realizing that the float bowls were not polished from the factory, I also used this method to shine them up.
Start off with 100 grit sand paper. This will cut through the corrosion, shape and smooth the metal. It will look like brushed aluminum as you go. Don't use a sanding blok and try to sand everything eavenly by hand. Use the 100 grit to remove any scracthes or blemishes. Next move to 220 grit, then 320. Next move to wet/dry sandpapers staring with 400. You will have to wetsand from here on out to avoid clogging the sandpaper and really make this work well. next move to 600, then 800.
Each time you move up in grit count the scratches should get smaller and smaller. It should look like brushed aluminum but the goal is to make the brushed look gradually diasappear while removing other surface imperfections. Each time you move up in grit count spend a little more time than you did on the lower grit counts. Things really start looking amazing when you switch to #00 steel wool. Rub the steel wool on the dashpot all over to remove most of the remaining marks from the sanpaper process. I often start wondering how it can get moch better at this point, but the final step is what will finish and protect the polish for a while.
Take your old sock and flip it inside out so the fuzzy side faces out. Pot a small amount of Mother's Aluminum Polish on the sock and rub it into the metal all over. You should see the polish turn black. Really buff it good here. Then take a clean part of the sock and run off the excess. Mothers will protect the shine for a while. You will have to eventually reapply, but as long as you maintain the polish, you wont have to go through the sanding process again. It took me about 3-4 hours to do two dashpots and two float bowls with this method. Take your time. Dont rush this, the more time you take in prepping the surface, the better the result will be.