Harbor Frieght Ball Joint Separator

 

The factory worskshop manual calls for tool 18G 1063 to separate the outer tie rod ends from the steering arms, and also to separate the rear shock links from the shock absorbers. This tool was made by Brown and Gammons, is highly collectable, no longer made, and very hard to find. However, near identical tools are still in production and are quite inexpensive. One such tool is Harbor Frieght's 3/4" ball joint separator. At about $20 it's hard to pass up. there are other ways to disconnect the tie rod ends from the steering arms, but I have never suceded using a prybar and a hammer like some have, and a pickle fork style separator will destroy the tie rod end boot, and may not even work as well or as quickly and effortlessly as the factory recommended tool (or this Harbor Frieght equivillant).

Its hard to say what exactly if any differences there are between 18G 1063 and this tool are without actually having the old tool in hand, but here are some excerps from the shop manual and some pictures of the Harbor Frieght tool. First the picture found in AKD 4021 (12th Edition) section S.

Now the harbor frieght tool (click to enlarge).

Clearly whatever differences there may be between the factory tool and this Harbor Frieght tool, are minor. Both function exactly the same way. You slip the fork between the ball joint and whatever you are trying to separate it from, and the lever goes on the end of teh balljoint where the nut goes. You then tighten down the bolt on the tool and the ball joint pops right out. This tool is designed to be used with a 19mm socket and works well with either an impact tool, or a 1/2" drive hand ratchet. I highly recommend it.