Homemade Kingpin Reamer

 

The kingpin bushings must be reamed after installation. Moss used to sell a very expensive tool for the job. Some MG or Austin Healey clubs have one they loan out to members but if you dont have access to a loaner, or dont like the idea of shelling out hundreds of dollars to do the job, you might try this first. The following was submitted by Jeremy Mulder on the MG Experience forum

Well I did mine this last weekend and I must say it was easier than I expected. The bushings pressed out with little effort on a 20 ton shop press, and the new ones went in even easier. As for the reamer it is 100% necessary to get it all to fit back up. My new pins would not even think of sliding into the new bushings. They must be reamed. I got a bit creative and made my own reamer from the old kingpins. I cut some flutes into them and turned them by hand until they slid in. Then since the old pins were a bit undersized due to wear I used some fine sandpaper on a drill to fine tune the fitment. Took about 10 minutes per side between pressing and reaming. Result is I now have nice tight fitting pins that should last a long time. Pic of my handy tool and the finished product.