Greasing the Front U-Joint

 

Not all U-joints come with zerks to grease them with, but some do. Believe it or not all a-series spridgets have a small acess hole in the tunnel to facilitate greasing the front u-joint (normally filled by a small rubber plug of course). Its on the left side of the transmission tunnel near the floor and somewhere between the shifter and the handbrake (see pictures below). Idealy the u-joint would have been installed with the zerk or grease fillting pointing slightly towards the rear of the car. If it points towards the front it may become difficult or impossible to grease. You may need to move the seat to get access to this. Removing the seat entirely may make it even easier but this probibly isn't necessary.

Later 1500 cars have a large "inspection hole" undernieth because the front driveshaft yoke actually bolts onto a flange on the output shaft of the gearbox (the sliding joint is in the driveshaft itself). A-series engined cars simply have the sliding joint in the tail extension of the gearbox. I'm not sure if the earlier grease acess hole was deleted from later cars but it may have been.