How to Use a 68 Camaro Wire Set on a spridget

 

This tech tip is especially handy if you have a 25D distributor (or earlier) with a side entry cap. This cap is pretty much standard equipment on spridgets from 1958 to the introduction of the 1500 in about 1975. The factory part number for this cap was 57H 5477. This cap uses screws to connect and hold in place the ends of the ignition wires. The screws have sharp ends that pierce the wires to do these two crucial functions. See images below.

25D side entry cap 25D Side Entry Cap Front Elevation 25D Side Entry Cap

 

This design has some drawbacks but one advantage that makes it a really nice cap to use on your car. The drawbak is that the terminal screws often sieze up and dont want to loosen once installed on a car and used for many seasons of driving. Also, unles sthe wires are cut nice and flat on the cut end, and fully seated in the bore, the screw wont make a good connection or firmly hold the wire in place. Finally, it limits the diameter of your wires to 7mm. That isnt too bad, but it does limit what wire sets you can use.

Despite all of that, it has a trick up it's sleeve. Since you only need a connector on one end of the wire, it doesnt matter a whole lot what wire set you use for the car. As long as you have four 90º connections on one end of four wires, and a straight on connector on the 5th wire with aboot that will fit over the coil terminal, you can use it. As it turns out, not every auto parts store carries wire sets for spridgets, and they usually have to order them. What if you want to do a tune up right now, no waiting? You can easily get the plugs, and if you have access to a parts chain distribution center such as the NAPA store in Naperville, chances are they will have the cap, rotor, points and condensor on hand.

Well the answer is you buy a wire set for a 68 camaro. Preferably something with a chevy v8. The cost is actually a few bucks less than ordering the wire set for a midget or sprite and then having to pay a $10 shiping charge, PLUS you basically get two wire sets, maybe a few more if you have the tools to crimp on connectors of your own. Whatever wire set you use it MUST be 7mm diameter wires, be for a car that isnt OHC or coil on plug, and have 90º connectors on the spark plug end. I used NAPA part number 700134

The lengths you need to cut the wires to are as follows (make them no shorter than this).

Connection on Cap Length
Coil 7 1/2"
Cylinder 1 12"
Cylinder 2 8 1/2"
Cylinder 3 9 1/2"
Cylinder 4 11 1/4"