DIY Eezi-bleed 1

 

George Campbell of Ontario Canada recommends the following method for bleeding the clutch. This should work on any spridget that has separite clutch and brake masters.

Take a bicycle inner lube (1.75inch) and do the following:

  • Leave 15 inches on both side of the nipple where you fill it with air.
  • Take one cut end and put it over the master filler and clamp it.
  • Fill the tube with brake fluid up to the air nipple.
  • Take the other end and fold it over and clamp it with a pair of vise grips.
  • Take an air compressor and pressurize the master cylinder a bit.
  • Open the bleeter screw on the slave and THATS IT.

Took, ten minutes, $7 and I had a full on clutch pedal.

I drove this car after seven months and I'll tell you it was a great feeling.