Caurburettor Linkages: Twin SU

 

lots of people ask for pictures of the throttle linkages, and tips on how to install them. Understandable because one you have the carbs out of the car, its easy to forget how they went in. Standing on the right side of the car, facing the engine, the choke linkage will be the one closer to you, and the throttle linkage will be the one closer to the heat sheild. Both linkages are made of three pieces. There is a shaft, and then two lever and pin assemblies. The throttle linkage also has a counterweight/bell crank on it. This is what the cable and one of the three throttle return springs attach to. It must face the heat shield.

The British Motor Corparation service department had this to say about throttle linkages (AKD 4021B Section D/DA page D.5)

Throttle linkage

The throttle on each carburetter is operated by a lever and pin, with the pin working in a forked lever attached to the throttle spindle. A clearance between the pin and fork must be maintained when the throttle is closed and the engine at rest to prevent any load from the accelerator linkage and return springs being transferred to the throttle butterfly and spindle.

To set this clearance: with the throttle shaft levers free on the throttle shaft, put a .012 in. (.3 mm.) feeler between the throttle shaft stop at the top and the carburetter heat shield. Move the throttle shaft lever downwards until the lever pin rests lightly on the lower arm of the fork in the carburetter throttle lever. Tighten the clamp bolt of the throttle shaft lever at this position. When both carburetters have been dealt with, remove the feeler. The pins on the throttle shaft levers should then have clearance in the forks.

Reconnect the choke cable, ensuring th at the jet heads return against the lower face of the jet adjusting nuts when the choke control is pushed fully in.

Pull out the mixture control knob on the dash panel until the linkage is about to move the carburetter jets (a minimum of t in. or 6 mm.) and adjust the fast idle adjusting screws to give an engine speed of about 1,000 r.p.m. when hot .

They show the following diagram

However, The manual doesnt help much because it the drawing doen't have the best camera angle and then there is the inaccuracies about the clearences. The feeler guage thing is a bit confusing since there is no way that the throttle linkage is ever going to have a .012" clearence between it and the heat sheild (at least on most cars). What the feeler guage in the drawing is actually used for in this case is to hold the throttle linkage in place while you make some adjustments. However, that isnt needed because if this adjustment is to work properly, the linkage must be held in place by the the cable and the spring. The idea is that the throttle butterflies are closed only by the return spring attached to them and that the linkage should be set up so that the spring attached to the throttle stop (its the pie slice shaped lever sticking out of it) is what holds the trottle cable in tension. You don't want the throttle cable to hold the throttle wide open or allow the spring to give extra force to hold it closed. Properly adjusting the trottle linkage makes the pedal feel more responsive. There are actually clearence specifications for the link pins. To do this you will need to loosen the throttle cable stop a bit and make some adjustment there too. See this illustration from "Tuning SU Carburettors"

There are no clearence specifications for the choke linkage, it's only important that the two chokes start moving at the same time when you pull on the choke cable. Here are some pictures of the whole setup. Notice tha the nuts are facing upwards on the linkages, this makes everything a lot easier to adjust.